Description
Rifle Case Product Details
Case Club Springfield M1A Pre-Cut Waterproof Rifle Case with Accessory Box and Silica Gel to Help Prevent Gun Rust (Gen 2)
Rifle Case Product Features
Pre-cut foam holds a single factory Springfield M1A Scout Squad, SOCOM 16, Standard, Loaded, National Match, Super Match, or Garand Rifle (Not meant to fit Springfield M1A CQB stock)
Holds up to six 10 round magazines, or three 20 round magazines & accommodates all major optics mounted either in the forward position or above the rear sight
Stainless steel added to padlock points for added security, Orange peel texture added to exterior finish to minimize scratches, Structural ribs added to outside of case for increased durability, Front handle length increased to help counter balance off center weighted loads, Wide bodied snap latches that can be used with gloves
Foam insert is (closed cell) high grade polyethylene which can be wiped clean
Case is Airline Approved for checked luggage, padlockable, wheeled, fully shippable & dustproof
Heavy Duty Protection – Upgraded Gen 2 Design
Engineered durability that will perform under the most harsh conditions. Hard polymer case shell is built tough and ready to keep your gear safe under the most extreme conditions.
Durable Case Shell with Stainless Steel Hardware
Impervious to rust & corrosion from salt water & solvents.
100% Waterproof
Rugged case design is IP67 rated & can be submerged without water penetration.
100% Dustproof
Heavy duty gasket keeps dust, debris & particulates out.
O-Ring Seal Built Into the Lid
Rubber gasket keeps water and dirt out making the case fully waterproof and ready for action.
Watertight Gasket Seal
Stainless Steel Hinge Pin
Multiple Padlock Points
Manual Purge Valve
Exterior Case Dimensions
Exterior Dimensions
